Hey everyone, I was able to take home 2 of the above rack mount servers. I powered them up and hooked up a VGA cable to monitor (tested cable and monitor so I know both are good). I get nothing on the screen, the monitor falls asleep. These servers used to be behind Fl’s. They were basically shut down and now I have them (my work approved me taking these lol). Unfortunately, I do not have any of the IP information. I just purchased a RJ45 to USB connector to try and hook up to the management port on the back. Any suggestions on how to access? Before I took them home I did max them out with memory from other decommissioned nodes so I know the memory is compatible). I have 1.6TD SSD in slot one and 10 SAS 1.2TB in the rest. I read that maybe I need to change the node type? So that it can be accessed like a rack mount? I’m los and would love some advice! Thanks!
You must log in or register to comment.
These things must be so loud and probably use a lot of power.
Nah, I have an enclosed rack for them. Sounds like a nice hum. Nothings louder than these kids… 🤣🤣
As far as power, probably. But I’m not concerned with a higher electric bill.
Check the power supplies, quite a few UCS chassis will only operate at 208/240v. Also check that the CPU/RAM weren’t scavenged by a sticky-finger tech lol
Hahaha!! Good idea
Don’t these need different controllers for standalone use? The VIC used for connection to FI’s is a different piece of hardware I believe.
Nice servers! Hope you get them working - love my C240 M4 - although a bit noisier than the Dell R720 it replaced.
Be careful though - if you put non-Cisco parts (PCI-X boards, not the drives) in them they will run their fans at a much faster rate. Fortunately, genuine Cisco parts are relatively cheap on this retired hardware.
You can put them in a power efficient mode through the CIMC to keep the fan speed down a bit, which helps with the noise.
Those are sexy. One day…
RJ45 to USB for management console… on carpet.
🤦♂️
My brain hurts. Please stop.
Wait until you find out I forgot to push the power button! 🤣🤣
I just dragged a mobo across carpet for you :)
There’s a RJ45 management port, also serial on front. Also, it’s not plugged in. I was checking them before I put them in my enclosed rack. Which I started this morning.