Seriously, couldn’t they just extend the tube a bit so it overhangs the exhaust pipe???
The entire comment section seems to be missing this is assholedesign and offering the same shitty solutions without addressing the asshole design…
The operating procedure of the internet
- Scan feed
- Find post where I can ridicule OP in some way
- Engage
No, this is not asshole design. If the oil port was sticking further out, it’s gets knocked off if you lay the bike down. And then you have no oil at all, and a blown up motor.
It’s by good design the oil port is recessed. Yes it’s annoying to use a funnel, but it’s the preferable option.
?? Oil port would only need to be extended by like 0.5" to clear that exhaust pipe, the casing to the left extends probably 1-2" from that. If you lay the bike down it that casing would stop the oil port from being touched. Shouldn’t be an issue.
Does Lemmy have a “just rolled into the shop”? I would join instantly.
Well the problem with that is when you lay the bike down, the oil port gets shaved off and you lose all your oil. Don’t ask me how I know.
So yeah, it’s a PITA to use a funnel, but it’s still the preferable option.
I bet the maintenance guide says to use a funnel or something ¯\(ツ)/¯
Nope.
The engineering team that designed the engine never communicated with the engineering team that designed the motorcycle.
Keeps the exhaust pipe from rusting. /s
keeps the exhaust lubricated so it doesn’t seize up.
I knew it was good for something My indicators siezed up just last week, shoulda replaced the fluid.
What’s the big deal just spray some degreaser on it then take it for a big rip
That would cost $0.76 more in materials per vehicle, unacceptable!
A lot of bad can be said about Harleys but I love that my 48 just has a little rubber hose with a plug in it to drain the oil.
I assumed that it just fell out the engine naturally.
All this mess could have been prevented with a little bit of cardboard between the drain and the exhaust, you realise that I hope.
Smoldering cardboard doesn’t sound like a good idea.
Good luck lighting cardboard on fire with an exhaust
All fire needs is heat, oxygen, and fuel. You’ve got all of that there.
The exhaust gets hot enough to burn off oil when it’s idling, so I’m sure it’s hot enough to burn cardboard.
I’m not going to risk it, the tinfoil idea sounds like the goer here.
Super duke is like this too I just put aluminum foil over the exhaust.
What does that do?
Keeps ‘THEM’ from reading the exhaust pipe’s mind.
Keeps oil from getting on the exhaust.
Problems such as these are usually a management failure. The design of individual components are often owned by a particular person or small group. They take responsibility for the design and testing. If one person owns the sump and another person owns the exhaust pipe, their work needs to be coordinated in such a way that the finished product meets all its goals. It wouldn’t be a surprise to find out that the exhaust engineer had to re-route the pipe in order to resolve some other clash and they ran out of time to fix the new problem before mass production had to start. Making complex machinery is difficult.
How about instead of playing a victim, stick a piece of tin foil over the pipe?
yeah, let’s blame the user for not fixing the manufacturer’s shitty design
The oil should change itself 😥
