Been daily driving low-profile Gateron switches for a while but wanted to give MX another shot. Mostly so I can use my nice keycaps again. I didn’t buy this filament specifically for this build but I think it works really nicely.
Switches are Ergo Clears, lubed and filmed with (IIRC) 45g springs. They were previously on an Ergodox and barely got any use as I switched to smaller boards shortly after modding them and wasn’t comfortable with desoldering yet, so I’m happy to have finally found a new home for them.
Caps are MT3 Godspeed, case is Overture Matte PLA (light blue and white), printed on the Sovol SV06 Plus.
I like it! Although I would prefer 3x6.
There are some similar boards with 3x6 layouts - ffkb and vulpes majora, both by fingerpunch, support 3x6 with a center trackball. I do miss the extra keys a bit with 3x5 layouts - when I eventually design my own board I think I’m going to do a 40 key layout.
I’ve looked at those but the 6th column stagger is a bit much for me with those.