• derpgon@programming.devEnglish
      3·
      12 days ago

      Do they cut corners? If not, it might not bee that bad for cityblock bases where the spacing is one chunk.

  • BombOmOm@lemmy.worldEnglish
    151·
    13 days ago

    In defense of the new tracks, the trains did seem to careen around corners a bit too much.

    I’ll tell you what though, took me awhile to figure out why nothing was lining up properly. I have a saved blueprint that is just two lengths of straight track with a rail signal on both, set to the length of a 1 engine, 4 car train and separated by the width of a (not in the blueprint) turnaround. Yeah…that blueprint needed a quick adjustment after laying down way too much track.

  • Worx@lemmynsfw.comEnglish
    11·
    13 days ago

    FYI: any old rail seems to have been converted to “legacy rail” which isn’t the same as normal rail. I found that I couldn’t place my (old) blueprints down on top of (new) rail that I’d placed manually because the tracks aren’t technically the same

    • Cethin@lemmy.zipEnglish
      2·
      10 days ago

      As in single-lane two-way or two-lane two-way (single-way per lane)?

      Either one is pretty easy. Single-lane you just put chain signals on both sides on entering the segment. This may be all you need, but for longer stretches you’ll want a sidetrack. This is just a parallel segment that’s one-way on both sides (in Factorio, real life can have either direction sidetrack). This breaks your rail into segments, so a train can move up to the sidetrack and wait for a train coming the other way clear it, instead of waiting all the way back at the station for a clear path.

      Two-lane is harder to build but easier to manage. Any large-scale network will probably use this, at least for busy tracks. You just need to make sure your signals are only on the right-hand side of the rail (if you want left-handed travel then put them on the left instead). Chain signal when entering an intersection and rail signal when existing, unless there’s not enough room for a train ahead before the next intersection.

      I’ve got a mix of both of these. Most of my rails to resource patches are single-lane, because they don’t get much traffic. My factory is two-lane.