We used to have a fancy ass fire alarm system in the 90s and early 2000s. At a couple of points in the house there were detectors, each with a battery, power connected and connected to each other. If one of them detected smoke or heat, they would all start beeping. They would flash every 10 secs to let you know it is in sync, but they would also emit a small beep every 10 mins or so. They never ran out of power since they were connected to mains voltage with a battery backup. The battery was rated to be replaced every 10 years, but I think it was one of those that basically went on forever.
I got used to it after a while, but every now and again I would start noticing the beeps and could not stop noticing them. My dad was proud of them, he paid a lot of money to get them and get them installed.
I’ve lived in a place with a fire alarm system like that, but the beep is because the backup battery is flat or the unit needs to be replaced.
Most smoke detectors are essentially a small radioactive lump with a Geiger counter next to it; if smoke gets in between it blocks the radiation and if the number of radiation “hits” falls below a threshold in a set time period the alarm goes off. So, as radioactive things have a half life, there’s a point where the radiation emitted falls below the original threshold and you need to replace it. We fucked around with the batteries in ours for ages assuming one of them was low, but eventually replaced the detector itself and the beeping stopped.
Nope these ones did it from the get go. We asked about it when they got installed, it was a feature to let you know they were operating properly. I really to this day don’t know why it was like that.
It wasn’t a loud beep, when the TV was on, you couldn’t even hear it. I only heard it when it was quiet in the house, especially when I wanted to sleep.
We used to have a fancy ass fire alarm system in the 90s and early 2000s. At a couple of points in the house there were detectors, each with a battery, power connected and connected to each other. If one of them detected smoke or heat, they would all start beeping. They would flash every 10 secs to let you know it is in sync, but they would also emit a small beep every 10 mins or so. They never ran out of power since they were connected to mains voltage with a battery backup. The battery was rated to be replaced every 10 years, but I think it was one of those that basically went on forever.
I got used to it after a while, but every now and again I would start noticing the beeps and could not stop noticing them. My dad was proud of them, he paid a lot of money to get them and get them installed.
What kind of madman designs something like this?
I’ve lived in a place with a fire alarm system like that, but the beep is because the backup battery is flat or the unit needs to be replaced.
Most smoke detectors are essentially a small radioactive lump with a Geiger counter next to it; if smoke gets in between it blocks the radiation and if the number of radiation “hits” falls below a threshold in a set time period the alarm goes off. So, as radioactive things have a half life, there’s a point where the radiation emitted falls below the original threshold and you need to replace it. We fucked around with the batteries in ours for ages assuming one of them was low, but eventually replaced the detector itself and the beeping stopped.
Nope these ones did it from the get go. We asked about it when they got installed, it was a feature to let you know they were operating properly. I really to this day don’t know why it was like that.
It wasn’t a loud beep, when the TV was on, you couldn’t even hear it. I only heard it when it was quiet in the house, especially when I wanted to sleep.
Ah yes, the Everything’s Okay Alarm.