If you’re able to immediately identify an object, it won’t automatically. You are able to select the unidentified item, and select Identify. Then it is fully identified, but you lose the shard’s bonus for that item.

You can’t just say “perchance”!

Yes, thanks for adding that. I think I ended up going back using a levitation potion.

Thanks. I hate it. Lol

Let’s see. Spend several minutes composing a few paragraphs, followed by revising because of errors in composition, spelling,or grammar…or simply spend a few seconds with AI. Work smarter not harder.

Many suggest adding some type of adhesive to the surface, and I have a trick that might interest you. Glue sticks and hairspray are messy and are a pain to clean. When I used a glass bed, I kept about a tablespoon of sugar dissolved in little less than a cup of water nearby. One could use a paper towel to wipe a thin film over your glass bed. I did this as it warmed up and the water dried quickly, leaving a thin tacky surface. One could put it in a small spray bottle too. Very easy to clean with water. If you eventually get buildups after weeks of printing, a quick wash with soapy water cuts through instantly. Give it a try. I could never get PLA to stick to my glass bed. PETG worked sometimes, and other times it bonded too well and broke the glass when it was removed, or cooled to the point of removing. The sugar water worked there too in providing a sacrificial layer that protected the glass and made removal easier.

I put on my robe and wizard hat